🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
IEEE 1812 2015

IEEE 1812 2015

$48.75

IEEE Trial-Use Guide for Testing Permanent Magnet Machines

Published By Publication Date Number of Pages
IEEE 2015 56
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

New IEEE Standard – Active. Contained in this trial-use guide are instructions for conducting tests to determine the performance characteristics and machine parameters of permanent magnet (PM) machines. The tests described may be applied to motors and generators, as needed, and no attempt is made to partition this guide into clauses applying to motors and clauses applying to generators. It is not intended that this guide shall cover all possible tests, or tests of a research nature, but only those general methods that may be used to obtain the performance data and machine parameters. The schedule of factory and field tests, which may be required on new equipment, is normally specified by applicable standards or by contract specifications. This guide should not be interpreted as requiring any specific test in a given transaction or implying any guarantee as to specific performance indices or operating conditions. The term specified conditions for tests as used in this guide will be considered as rated conditions unless otherwise agreed upon. Rated conditions apply usually to the quantities listed on the machine nameplate.

PDF Catalog

PDF Pages PDF Title
1 IEEE Std 1812-2014 Front cover
3 Title page
5 Important notices and disclaimers concerning IEEE standards documents
8 Participants
10 Introduction
11 Contents
13 Important notice
1. Overview
1.1 Scope
1.2 Purpose
14 1.3 Organization of the guide
1.4 Instrumentation
15 2. Normative references
3. Condition and integrity tests
16 3.1 Resistance measurement
3.2 Phase sequence
17 3.3 Insulation resistance
3.4 Dielectric and partial discharge tests
3.5 Polarity tests for magnets
3.6 Shaft and bearing current
3.7 Over-speed tests
18 3.8 Resistance to demagnetization
3.9 Acoustic noise
3.10 Vibration
4. Steady-state tests
4.1 Introduction to steady-state tests
4.2 Open-circuit tests
26 4.3 Short-circuit tests
30 4.4 Load tests
34 4.5 Thermal performance
36 5. Transient tests
5.1 Retardation test
39 5.2 Sudden short-circuit test
41 6. Machine operating characteristics
6.1 Stator voltage waveform
6.2 Losses and efficiency
45 6.3 Thermal capability
6.4 Torque ripple
49 Annex A (informative) Bibliography
50 Annex B (normative) Nomenclature
51 Annex C (informative) Background on demagnetization
52 C.1 Stator faults
C.2 Asymmetric demagnetization
53 C.3 Detection of demagnetization
C.4 Demagnetization due to temperature
56 Back cover

Related products

IEEE 1812 2015
$48.75