BS EN ISO 2759:2014
$142.49
Board. Determination of bursting strength
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 24 |
This International Standard specifies a method for measuring the bursting strength of board submitted to increasing hydraulic pressure. It is applicable to all types of board (including corrugated and solid fibreboard) having bursting strengths within the range 350 kPa to 5 500 kPa. It is also applicable to papers or boards having bursting strengths as low as 250 kPa if the paper or board is to be used to prepare a material of higher bursting strength, such as corrugated board. In such cases, the measurements will not necessarily have the accuracy or precision stated for this method and it is necessary to include a note in the test report stating that the test gave results that were below the minimum value required by the method.
In the absence of any commercial agreement as to which method should be used for materials with bursting strengths between 350 kPa and 1 400 kPa, all materials with bursting strengths below 600 kPa, except components of solid and corrugated fibreboard, should be tested by ISO 2758 and the remainder by this International Standard.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_3.2 Section sec_4 1 Scope 2 Normative references 3 Terms and definitions 4 Principle |
| 10 | Section sec_5 Section sec_5.1 Section sec_5.2 Section sec_5.3 Section sec_5.4 5 Apparatus |
| 11 | Section sec_6 Section sec_6.1 Section sec_6.2 Section sec_7 Section sec_8 Table tab_1 6 Calibration 7 Sampling and preparation of test pieces 8 Procedure |
| 12 | Section sec_9 Section sec_10 9 Expression of results 10 Test report |
| 14 | Annex sec_A Table tab_b Figure fig_A.1 Annex A (normative) Dimensions of the clamping system |
| 15 | Table tab_c Figure fig_A.2 |
| 16 | Annex sec_B Annex B (normative) Testing the clamps |
| 17 | Annex sec_C Annex C (normative) Clamping pressure |
| 18 | Annex sec_D Annex sec_D.1 Annex sec_D.2 Annex D (normative) Calibration of pressure-measuring system |
| 19 | Annex sec_E Annex sec_E.1 Annex sec_E.2 Table tab_E.1 Annex E (informative) Precision |
| 20 | Table tab_E.2 Annex sec_E.3 Table tab_E.3 Table tab_E.4 |
| 21 | Reference ref_1 Reference ref_2 Reference ref_3 Reference ref_4 Reference ref_5 Reference ref_6 Reference ref_7 Reference ref_8 Reference ref_9 Bibliography |
Related products
-
AS 1301.438:2019
Methods of test for pulp and paper – Bursting strength of board (ISO 2759:2014, MOD)…
