🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BS EN IEC 60695-2-11:2021 – TC:2022 Edition

BS EN IEC 60695-2-11:2021 – TC:2022 Edition

$134.27

Tracked Changes. Fire hazard testing – Glowing/hot-wire based test methods. Glow-wire flammability test method for end products (GWEPT)

Published By Publication Date Number of Pages
BSI 2022 52
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This part of IEC 60695 specifies a test method on an end product. It is intended to simulate the effects of thermal stresses produced by an electrically heated source to represent a fire hazard. This test method is used to check that, under defined test conditions, an end product exposed to an electrically heated source has either a limited ability to ignite or, if it ignites, a limited ability to propagate flame. However, the fire hazard analysis, the flammability aspects and the flame spreading to other products are not covered by this document. This basic safety publication focusing on safety test method(s) is primarily intended for use by technical committees in the preparation of safety publications in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.

PDF Catalog

PDF Pages PDF Title
32 undefined
34 European foreword
Endorsement notice
35 Annex ZA (normative) Normative references to international publications with their corresponding European publications
36 English
CONTENTS
37 FOREWORD
39 INTRODUCTION
40 1 Scope
2 Normative references
3 Terms and definitions
42 4 Test specimens
4.1 General
4.2 Complete end product
43 4.3 Partial end product (alternative)
4.4 Test considerations and limitations associated with the specimen configuration
44 5 Test apparatus
6 Verification of the temperature measuring system
7 Conditioning
7.1 Conditioning of test specimens
Figure 1 – Small parts
45 7.2 Conditioning of specified layers
7.3 Testing conditions
8 Test procedure
8.1 General
8.2 Test temperatures
Table 1 – Test temperatures
46 8.3 Number of test specimens
9 Observations and measurements
10 Evaluation of test results
11 Test report
47 12 Information to be given in the relevant product standard
48 Annex A (informative) Suggested GWEPT temperatures
49 Figure A.1 – Suggested GWEPT temperatures
50 Bibliography

Related products

BS EN IEC 60695-2-11:2021 - TC
$134.27