BS EN 61300-2-42:2014
$86.31
Fibre optic interconnecting devices and passive components. Basic test and measurement procedures – Tests. Static side load for strain relief
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 14 |
IEC 61300-2-42:2014 specifies a test to determine the influence of a side load applied to a cord assembled with a strain relief. The intention is to simulate a static load, due to a length of fibre cable, which would typically be experienced during service. Components should withstand side loads during optical transmission without degradation of the optical performance. Besides a boot, any feature that controls the bending radius of the fibre can be considered as strain relief. This third edition cancels and replaces the second edition published in 2005 and constitutes a technical revision. This edition includes the following significant technical change with respect to the previous edition: modification of the severity according to cable configurations. Keywords: side load, static load, optical performance, strain relief
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword Endorsement notice |
| 5 | Annex ZA (normative) Normative references to international publications with their corresponding European publications |
| 6 | English CONTENTS |
| 7 | 1 Scope 2 Normative references 3 General description 4 Apparatus 4.1 Load generator |
| 8 | 4.2 Holding fixture 4.3 Optical source and detector 5 Procedure 5.1 Preparation of specimens 5.2 Pre-conditioning 5.3 Initial measurements 5.4 Conditioning |
| 9 | 5.5 Measure the attenuation 5.6 Apply cable load 5.7 Monitor attenuation 5.8 Recovery Figure 1 – Test apparatus for static side load |
| 10 | 5.9 Final measurements and examinations 5.10 Repeated testing 6 Severity Table 1 – Severities |
| 11 | 7 Details to be specified |
