ASTM-G6 2007(Redline)

This procedure defines a test method for comparing the relative resistance of pipeline coatings to abrasion.

Abrasion resistance may be used to specify optimum coating thickness of candidate materials both in development and research work to study new coating systems or methods and in quality control.

1. Scope

1.1 This test method of accelerated test is a procedure for determining the relative resistance of steel pipeline coatings to abrasion by a slurry of coarse abrasive and water. The method is intended to apply to the testing of all types of electrical insulating pipeline coatings and tapes, including thermoplastics, thermoset, and bituminous materials.

1.2 Pipeline coatings are not normally subjected to the type of abrasion herein specified.

1.3 Metallic protective coatings such as zinc may be compared visually, but do not meet the electrical requirements of this test method.

1.4 The values stated in SI units to three significant decimals are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

G12 Test Method for Nondestructive Measurement of Film Thickness of Pipeline Coatings on Steel G62 Test Methods for Holiday Detection in Pipeline Coatings

Keywords

abrasion; coatings; pipeline; revolving; slurry;

ICS Code

ICS Number Code 25.220.20 (Surface treatment)

DOI: 10.1520/G0006-07 ASTM International is a member of CrossRef.

Citing ASTM Standards

[Back to Top]