Shopping Cart

No products in the cart.

ASTM-E1725:2007 Edition

$44.96

E1725-07 Standard Test Methods for Fire Tests of Fire-Resistive Barrier Systems for Electrical System Components

Published By Publication Date Number of Pages
ASTM 2007 11
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 These test methods cover fire-test-response.

1.2 These fire-test-response test methods provide information on the temperatures recorded on the electrical system component within a fire-resistive barrier system during the period of exposure.

1.3 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions

1.4 Potentially important factors and fire characteristics not addressed by these test methods include, but are not limited to:

1.4.1 The performance of the fire-resistive barrier system constructed with components other than those tested.

1.4.2 An evaluation of the functionality of the electrical system within the fire-resistive barrier system.

1.4.3 An evaluation of the ampacity of the electrical system within the fire-resistive barrier system.

1.4.4 An evaluation of the smoke, toxic gases, corrosivity, or other products of heating.

1.4.5 A measurement of the flame spread characteristics over the surface of the fire-resistive barrier system.

1.4.6 An evaluation of through-penetration sealing methods.

1.4.7 Combustibility of materials in the fire-resistive barrier system or of the electrical system components.

1.4.8 The need for supports beyond those normally required.

1.4.9 Environmental conditions in the area of service.

1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Significance and Use
2 Control of Fire Test
3 FIG. 1
4 Specimen Construction
FIG. 2
5 FIG. 3
FIG. 4
6 Conditioning
Specimen Instrumentation
FIG. 5
7 FIG. 6
8 Conditions of Acceptance
FIG. 7
9 Procedure
Report
Precision and Bias
Keywords
X1. COMMENTARY
X1.1
X1.2
X1.3
10 X2. SIGNIFICANCE AND USE
X2.1
X2.2
X3. TEST DESIGN
X3.1
X3.2
ASTM-E1725
$44.96