ASTM-D5677 2005
$40.63
D5677-05 Standard Specification for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type, for Aviation Jet Turbine Fuel Lines
| Published By | Publication Date | Number of Pages |
| ASTM | 2005 | 5 |
1.1 This specification covers a reinforced plastic pipe and fittings system made from epoxy resin and glass-fiber reinforcement, together with adhesive for joint assembly, intended for service up to 150F (65.6C) and 150-psig (1034-kPa) operating pressure and surges up to 275 psig (1896 kPa) in aviation jet turbine fuel lines installed below ground.
1.2 The dimensionless designator NPS has been substituted in this specification for such traditional terms as nominal diameter, size, and nominal size.
1.3 The values stated in inch-pound units are to be regarded as standard. The values in parentheses are for information only.
The following safety hazards caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1
There is no similar or equivalent ISO standard.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology Classification |
| 2 | Materials and Manufacture Dimensions Performance Requirements TABLE 1 |
| 3 | Workmanship Test Methods |
| 4 | Inspection |
| 5 | Certification Product Marking Packaging Keywords |
Related products
-
ASTM-D5627 2004
D5627-94(2004) Standard Test Method for Water Extractable Residue from Particulate Ion-Exchange Resins Published By Publication…
-
ASTM-D6677 2001
D6677-01 Standard Test Method for Evaluating Adhesion by Knife Published By Publication Date Number of…
-
ASTM-D5670 2009
D5670-95(2009) Standard Test Method for Rubber-Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by…
-
ASTM-D5607 2008(Redline)
D5607-08 Standard Test Method for Performing Laboratory Direct Shear Strength Tests of Rock Specimens Under…
-
ASTM-D6577 2000
D6577-00 Standard Guide for Testing Industrial Protective Coatings Published By Publication Date Number of Pages…
-
ASTM-D5277 2008
D5277-92(2008) Standard Test Method for Performing Programmed Horizontal Impacts Using an Inclined Impact Tester Published…
-
ASTM-D5977 2003
D5977-03 Standard Specification for High Load Rotational Spherical Bearings for Bridges and Structures Published By…
-
ASTM-D5667 2005
D5667-95(2005) Standard Test Method for Rubber From Synthetic Sources-Total and Water Soluble Ash Published By…
-
ASTM-D5637 2005
D5637-05 Standard Test Method for Moisture Resistance of Electrical Insulating Varnishes Published By Publication Date…
-
ASTM-D5673 2015
D5673-15 Standard Test Method for Elements in Water by Inductively Coupled Plasma—Mass Spectrometry Published By…
-
ASTM-D5678 2002
D5678-95(2002) Standard Test Method for Freeze/Thaw Resistance of Wax Emulsion Floor Polish Published By Publication…
-
ASTM-D5607 2006
D5607-02(2006) Standard Test Method for Performing Laboratory Direct Shear Strength Tests of Rock Specimens Under…
-
ASTM-D5678 2008
D5678-95(2008) Standard Test Method for Freeze/Thaw Resistance of Wax Emulsion Floor Polish Published By Publication…
-
ASTM-D5637 2000
D5637-00 Standard Test Method for Moisture Resistance of Electrical Insulating Varnishes Published By Publication Date…
-
ASTM-D5877 2005
D5877-95(2005) Standard Guide for Displaying Results of Chemical Analyses of Groundwater for Major Ions and…
-
ASTM-D5687 2007
D5687/D5687M-95(2007) Standard Guide for Preparation of Flat Composite Panels with Processing Guidelines for Specimen Preparation…
-
ASTM-D5667 2015
D5667-95(2015) Standard Test Method for Rubber From Synthetic Sources—Total and Water Soluble Ash Published By…
-
ASTM-D5577 2003
D5577-94(2003) Standard Guide for Techniques to Separate and Identify Contaminants in Recycled Plastics Published By…
-
ASTM-D5777 2000
D5777-00 Standard Guide for Using the Seismic Refraction Method for Subsurface Investigation Published By Publication…
-
ASTM-D3677 2015
D3677-10(2015) Standard Test Methods for Rubber—Identification by Infrared Spectrophotometry Published By Publication Date Number of…
-
ASTM-D5077 2015
D5077-90(2015) Standard Terminology Relating to Electrostatic Discharge (ESD) Packaging Materials Published By Publication Date Number…
-
ASTM-D6577 2015
D6577-15 Standard Guide for Testing Industrial Protective Coatings Published By Publication Date Number of Pages…
-
ASTM-D5672 2003
D5672-03 Standard Test Method for Testing Flexible Cellular Materials Measurement of Indentation Force Deflection Using…
-
ASTM-D5377 2002
D5377-93(2002) Standard Classification for Rubber Compounding Materials—Ground Coal Published By Publication Date Number of Pages…
-
ASTM-D5977 2015
D5977-15 Standard Specification for High Load Rotational Spherical Bearings for Bridges and Structures Published By…
-
ASTM-D5377 2007
D5377-93(2007) Standard Classification for Rubber Compounding Materials—Ground Coal Published By Publication Date Number of Pages…
-
ASTM-D5877 2000
D5877-95(2000) Standard Guide for Displaying Results of Chemical Analyses of Ground Water for Major Ions…
-
ASTM-D4677 2002
D4677-87(2002) Standard Classification for Rubber Compounding Materials—Titanium Dioxide Published By Publication Date Number of Pages…
-
ASTM-D5657 2007
D5657-07 Standard Test Method for Fluid Tightness Ability of Adhesives Used on Threaded Fasteners Published…
-
ASTM-D5477 2002
D5477-02 Standard Practice for Identification of Polymer Layers or Inclusions by Fourier Transform Infrared Microspectroscopy…
-
ASTM-D5679 2001
D5679-95a(2001) Standard Practice for Sampling Consolidated Solids in Drums or Similar Containers Published By Publication…
-
ASTM-D6677 2007
D6677-07 Standard Test Method for Evaluating Adhesion by Knife Published By Publication Date Number of…
-
ASTM-D5672 2009(Redline)
D5672-09 Standard Test Method for Testing Flexible Cellular Materials Measurement of Indentation Force Deflection Using…
-
ASTM-D5657 2007(Redline)
D5657-07 Standard Test Method for Fluid Tightness Ability of Adhesives Used on Threaded Fasteners (Redline)…
-
ASTM-D5607 2008
D5607-08 Standard Test Method for Performing Laboratory Direct Shear Strength Tests of Rock Specimens Under…
-
ASTM-D5647 2007
D5647-07 Standard Guide for Measuring Hairiness of Yarns by the Photo-Electric Apparatus Published By Publication…
-
ASTM-D5677 2000
D5677-00 Standard Specification for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type,…
-
ASTM-D5672 2009
D5672-09 Standard Test Method for Testing Flexible Cellular Materials Measurement of Indentation Force Deflection Using…
-
ASTM-D5637 2005(Redline)
D5637-05 Standard Test Method for Moisture Resistance of Electrical Insulating Varnishes (Redline) Published By Publication…
-
ASTM-D5673 2005
D5673-05 Standard Test Method for Elements in Water by Inductively Coupled Plasma-Mass Spectrometry Published By…
