AWWA C707 2022

$76.92

AWWA C707-22 Encoder-Type Remote-Registration Systems for Cold-Water Meters

Published By	Publication Date	Number of Pages
AWWA	2022

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This standard covers encoder-type remote-registration systems for use on cold-water meters for water utility customer service, particularly the materials and workmanship employed in the fabrication and assembly of the on-meter registers. This standard can be referenced in specifications for purchasing and receiving cold-water meters for water utility customer service and can be used as a guide for fabricating and assembling encoder-type remote-registration systems for cold-water meters. The stipulations of this standard apply when this document has been referenced and then only to encoder-type remote-registration systems for cold-water meters for water supply service applications.

PDF Catalog

PDF Pages	PDF Title
9	Foreword I. Introduction. I.A. Background. The subcommittee that drafted this standard was formed in 1968. Initially, it attempted to formulate a single standard on remote-registration systems that would include both direct-reading and encoder-type systems. Because of design and a I.B. History. The first edition of this standard was approved by the AWWA Board of Directors on Jan. 26, 1975. The second edition was approved on Feb. 1, 1982 and reaffirmed on Jan. 26, 1992. The third edition of the standard was approved on Jan. 16, 2005 II. Special Issues. II.A. Metrication. Throughout this standard, metric equivalents (rounded off) are set in parentheses next to the customary units.
10	III. Use of This Standard. It is the responsibility of the user of an AWWA standard to determine that the products described in that standard are suitable for use in the particular application being considered. III.A. Purchaser Options and Alternatives. The following information should be provided by the purchaser: III.B. Modification to Standard. Any modification to the provisions, definitions, or terminology in this standard must be provided in the purchaser’s specifications.
11	IV. Major Revisions. Major changes made to the standard in this revision include the following: V. Comments. If you have any comments or questions about this standard, please call AWWA Engineering and Technical Services at 303.794.7711, FAX at 303.795.7603, write to the department at 6666 West Quincy Avenue, Denver, CO 80235-3098, or e-mail at stand
13	AWWA Standard SECTION 1: GENERAL Sec. 1.1 Scope Sec. 1.2 Purpose Sec. 1.3 Application
14	SECTION 2: REFERENCES SECTION 3: DEFINITIONS
16	SECTION 4: REQUIREMENTS Sec. 4.1 Materials Sec. 4.2 Design
21	SECTION 5: VERIFICATION SECTION 6: DELIVERY Sec. 6.1 Packaging and Shipping Sec. 6.2 Affidavit of Compliance