ASTM-UOP961:2012 Edition

$137.58

UOP961-12 Elemental Composition of Zeolites by ICP-OES

Published By	Publication Date	Number of Pages
ASTM	2012	12

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM UOP961-12

Active Standard: Elemental Composition of Zeolites by ICP-OES

ASTM UOP961

Scope

This method is for the determination of components in zeolites by Inductively Coupled Plasma-Optical Emission Spectroscopy (ICP-OES), following either a digestion or a fusion preparation. Ordinarily, the metals determined include aluminum (Al), calcium (Ca), cobalt (Co), chromium (Cr), copper (Cu), iron (Fe), gallium (Ga), potassium (K), lithium (Li), magnesium (Mg), manganese (Mn), molybdenum (Mo), sodium (Na), nickel (Ni), phosphorus (P), antimony (Sb), silicon (Si), tin (Sn), strontium (Sr), titanium (Ti), vanadium (V), zinc (Zn), and zirconium (Zr). Barium (Ba) and lead (Pb) cannot be determined in the digest due to the formation of insoluble sulfates. Barium can be determined from the fusion solution with a quantitation limit of approximately 0.01 mass-%. This method is suitable for samples containing less than 40 mass-% alumina (Al2O3) and less than 65 mass-% silica (SiO2); however, it can be readily expanded to samples with other silica/alumina ratios utilizing the same approach as described herein. Zirconium (Zr) at levels above about one mass-% can interfere with the analysis for aluminum when using some instruments, unless an alternative wavelength is used. Precision is about 1 to 2% relative standard deviation for elements present at concentrations greater than 0.1 mass-%. Mass balances between 98.5 and 101.5 mass-% are reported on a volatile-free basis. Precision below 0.1 mass-% does not exceed 10% relative down to the quantitation limits listed in Table 1.

Keywords

ICS Code

ICS Number Code

DOI:

Additional information