BS EN ISO 293:2003

$86.31

Plastics. Compression moulding test specimens of thermoplastic materials

Published By	Publication Date	Number of Pages
BSI	2003	12

Guaranteed Safe Checkout

Categories: 83.080.20 - Thermoplastic materials, BSI

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

General principles and procedures for preparing specimens directly or by cutting from moulded sheet. Specifies mould surfaces and conditions and four classified rates of cooling.

PDF Catalog

PDF Pages	PDF Title
1	BRITISH STANDARD
3	Contents
6	Foreword
7	0 Introduction 1 Scope and field of application 2 References 3 Definitions 3.1 moulding temperature 3.2 demoulding temperature 3.3 preheating time 3.4 moulding time 3.5 average cooling rate
8	3.6 cooling rate 4 Apparatus 4.1 Moulding press 4.2 Moulds
9	5 Procedure 5.1 Preparation of moulding material
10	5.2 Moulding 5.3 Cooling Table Cooling methods
11	6 Inspection of the moulded specimens or sheets 7 Test report Types of flash (“picture frame”) moulds Positive-type mould

Additional information

Publication Date	2003-07-15
Amends	BS 2782 MET 901A:1988 (R02)
Descriptors	Specimen preparation, Plastics and rubber technology, Thermoplastic polymers, Plastics, Cooling, Moulding (process), Test specimens, Polymers, Moulding equipment
Identical National Standard Of	ISO 293:1986, EN ISO 293:2003
Standard Number	BS EN ISO 293:2003
ISBN	0 580 16896 4
Replaced By	BS EN ISO 293:2005
Withdrawn Date	2006-01-10
Pages	12
Committee	PRI/21
Publisher	BSI
Replaces	BS 2782-9 Method 901A:1977
Title	Plastics. Compression moulding test specimens of thermoplastic materials
Status	Withdrawn
ICS Codes	83.080.20 - Thermoplastic materials

Preview PDF


PDF Format	Searchable	Printable	Preview Now

BS EN ISO 293:2003

PDF Catalog

Related products