Shopping Cart

No products in the cart.

BS EN 16296:2021

$102.76

Imperfections in thermoplastics welded joints. Quality levels

Published By Publication Date Number of Pages
BSI 2021 20
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This document specifies quality levels for imperfections in thermoplastics welded joints that have cooled to ambient temperature and is applicable to material thickness above 2,0 mm.

Three quality levels are specified in order to permit application for a wide range of welded fabrication. They are designated by symbols B, C and D, where B is the most stringent. The quality levels refer to production quality and not to the fitness-for-purpose (see 3.2) of the manufactured product.

The quality level necessary are expected to be defined by the application standard or by the fabricator in conjunction with the user and/or other parties concerned. The level is expected to be prescribed before the start of production, preferably at the enquiry or order stage.

This document applies to the following thermoplastic materials in Table 1:

Table 1
Thermoplastic materials

and to the following welding processes:

  1. heated tool welding;

  2. electrofusion socket welding;

  3. hot gas welding using filler rod only;

  4. extrusion welding;

  5. solvent welding of pipes.

PDF Catalog

PDF Pages PDF Title
2 National foreword
5 European foreword
6 Introduction
7 1 Scope
2 Normative reference
3 Terms and definitions
8 4 Quality levels
4.1 Classification
4.2 Choice of quality level
9 5 Requirements for welded joints
18 Bibliography
BS EN 16296:2021
$102.76